Please refer to The Flow Diagram of Forming Line & The Key Flow Diagram
① First, lift the steel coil and load it to the Un-coiler with derrick. Start the motor and then press the button to expand the inner-hole of the coil.
② Lead the coil tail to the Roll Former by hand. After adjust the Width-Limited Plane according to the feeding width, then setup the Roll Former, and lead it from hydraulic cutting device to Product rack.
③ When the panel reaches the cutting length required, the Roll Former will stop working and the hydraulic cutting device will setup to cut off.
④ After finished cutting, carry the Tile Panel from the Product rack to the designated place by hand. |